The following guide is for the installation of the iPassConnect client version 2.3 on Windows 98/ME/2000

The iPassConnect client has been updated to version 3, so it is recommended you install the updated version. If you wish to install version 2.3 instead, you will need to have a copy of the installer. If it was downloaded from iPrimus the filename should be ipass_Win_v2.30.exe. You will need to locate this file on your hard drive.

1. Double click ipass_Win_v2.30.exe to start the software installation.
   
   
2. The installation dialog will then appear as shown below. Click Next.
   
   
   
   
3. The installation destination path dialog will appear. Leave the directory set as the default by clicking Next.
   
   
   
   
4. The installation will then begin, followed by a completion dialog as shown below. Leave the tick in Launch iPassConnect then click Finish.
   
   
   
   
5. The iPass license agreement will then appear the first time the software is run. Click Accept to start using the iPass software.
   
   
   
   
6. An iPass Program message will appear. Click OK to continue.
   
   
   
   
7. iPass is now installed. To use iPass you must make sure your account is enabled for iPass by calling iPrimus on 1300 85 48 48.